Caratteristiche
- Cartuccia:
416 Remington Mag
- Peso della spedizione: 0,018kg
- Altezza di spedizione: 25mm
- Larghezza di spedizione: 51mm
- Lunghezza di spedizione: 102mm
Non disponibile.
N. prodotto: 100028222
N. fab.: LCGWFT2416RE
Avvisa quando diventa disponibile 39.9 EURIl WFT 2 è la nuova generazione di trimmer WFT, progettato per offrire prestazioni superiori e una maggiore versatilità.
La selezione delle camere di trimming sul WFT 2 è specifica per cartuccia, ma si basa sempre sulla famiglia di bossoli; basta ordinare la camera più grande della famiglia che si intende lavorare. Si prega di notare che questa unità e i suoi inserti non eseguono la smussatura o la rimozione delle bave all'orlo del bossolo mentre viene trimmato.
Se non riesci a trovare la cartuccia di cui hai bisogno, contatta il nostro Dipartimento Ordini Speciali al numero 800-741-0015.
416 Remington Mag
Itâs a work in progress 25/08/2018
This was difficult for me to get the adjustment right. I used the master case against the cutter and locked the set screws. Installed the trimmer in Dewalt drill and the cases came out .006 short the first time. I readjusted and now itâs + or - .002. Maybe Iâm too much a perfectionist. It is fast. The cutter has chips in the edges and some case chatter a bit till cut no matter how easy I insert the trimmer. Iâll order another cutter when theyâre in stock. Overall I believe most of my challenges are due to âoperator error!â Hence the 5 star rating.
Not the best choice 23/02/2017
I have to give credit to Little Crow Gunworks. They offered to take back my trimmer and fix it after I buggered it up. Using the dowlel to remove the insert caused the entire bottom bearing to pop out. Needed to hear the housing with a torch to get that back in. But I kept it, knowing I will never change out the trim chamber to trim another caliber.
Problems: The WFT required a half inch chuck. THat means your normal power drill will not work. That's just poor design thinking. Second, it is tough to clean. Third, as noted, it does not chamfer, so you get to double-work your brass. Last, it is not easy to adjust the cut height. Bottom line: there are better options.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.