Brownells Italia - Il negozio online del più grande rivenditore di componenti e accessori per armi da tiro, difesa e caccia Italia

SINCLAIR INTERNATIONAL
SINCLAIR STUCK CASE REMOVAL TOOL

749013572
We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
33.9 33.9 1 EUR
N. prodotto: 749013572
SINCLAIR INTERNATIONAL STUCK CASE REMOVER Abbiamo sviluppato questo strumento utile per aiutare a risolvere l'incubo secolare del ricaricatore; rimuovere un bossolo incastrato nella matrice di ridimensionamento. Questo accade quando il bordo del bossolo si strappa durante la discesa, lasciando il corpo del bossolo nella matrice, senza nulla da afferrare per tirarlo fuori. Lo strumento Sinclair Stuck Case Removal Tool ti permette di liberare il bossolo incastrato da qualsiasi matrice di ridimensionamento standard senza rischiare di danneggiare la matrice. Basta rimuovere la matrice dalla pressa e svitare il perno di sbavatura fino a che non esce dal foro di innesco. Blocca la matrice in una morsa e "filetta" la tasca dell'innesco e il foro di innesco utilizzando il trapano e il maschio inclusi, così puoi avvitare il corpo principale dello strumento nel foro. Man mano che stringi la vite di serraggio con una chiave esagonale standard da 3⁄16", lo strumento estrae ordinatamente il bossolo dalla matrice.
33.9 EUR 0 33,90 € *
In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.

Caratteristiche

Peso della spedizione: 0,126kg Altezza di spedizione: 13mm Larghezza di spedizione: 102mm Lunghezza di spedizione: 152mm

Dettagli dell'elemento

Made in Usa



We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
Newsletter