Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mount per RUGER PC CARBINE con Trijicon RMR: la scelta perfetta per il tuo mirino!
Scopri il mount EGW per il tuo RUGER PC CARBINE, progettato per adattarsi perfettamente al mirino Trijicon RMR. Questo mount è realizzato in 7075 Aluminum con un rivestimento Matte Black Hardcoat per garantire durata e resistenza.
Caratteristiche del prodotto:
- Dimensioni: Lunghezza totale: 1.780", Larghezza totale: 1.1"
- Hardware di montaggio: (2) viti a testa piatta 6-32, (1) vite di bloccaggio 6-32 X 3/16
- Compatibilità: Trijicon RMR, Holosun HS507C
- Modelli compatibili: Baby Desert Eagle (Post 2006), EAA Witness Elite Match
- Modelli non compatibili: Rock Island 1911s
Per installare il mount, rimuovi semplicemente il mirino posteriore della tua arma e sostituiscilo con il nostro mount, senza necessità di modifiche. Puoi rimuovere il mount e ripristinare il tuo mirino posteriore in qualsiasi momento. L'hardware di montaggio è incluso.
Istruzioni di installazione:
- Rimuovere il mirino posteriore*
- Installare il mount EGW nel dovetail
- Serrare la vite di bloccaggio (se applicabile)
- Posizionare il mirino a punto rosso sul mount EGW (inserire un piccolo pezzo di carta tra il mirino e il mount faciliterà la rimozione e impedirà il contatto con il Loctite)
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
Nota: Le viti incluse con questo mount richiedono una chiave a brugola da 5/64'' per l'installazione.