Caratteristiche
- Tipo di arma:
1911
- Peso della spedizione: 0,068kg
- Altezza di spedizione: 61mm
- Larghezza di spedizione: 61mm
- Lunghezza di spedizione: 226mm
- UPC: 050806020559
1911
IVA inclusa / spese di spedizione escluse
N. prodotto: 080771000
050806020559 Reamers extra lunghi ripristinano il tubo del plunger alla corretta I.D. dopo il staking - e forniscono ampio spazio per la molla per un funzionamento positivo.In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.
IVA inclusa / spese di spedizione escluse
Il PLUNGER TUBE REAMER SET di BROWNELLS è progettato per garantire un'installazione rapida e senza danni del tubo del pistone. Gli estrattori extra lunghi riportano il tubo del pistone alla corretta I.D. dopo la punzonatura, offrendo al contempo un'ampia clearance per la molla per un funzionamento positivo.
Questo set è essenziale per ogni appassionato di armi che desidera mantenere il proprio 1911 in condizioni ottimali.
1911
Not a Reamer 29/08/2017
1st off, they are not reamers! They are DRILL BITS. Care & a light touch must be used to keep them from biting into the steel. Drills are made for high speed. As soon as I tried to use them, both came loose from the handles. I had to super glue them into the handles to get them to work. However if used lightly and take your time, they will work. Brownells needs to fix the handle problem and change the heading from "Reamers" to "Hand drills". Kind of pricey for 2 drill bits with plastic handles, but they do work. As 35 yrs. as a Engineer/Tool & Die Maker, I know what I'm talking about.
Could be better II. 02/02/2016
The reamers are very sharp. The issue was the shaft attached in the handle broke free easily. I used the handle to hold the shaft straight, I applied slight pressure, and turned the shaft with vise grips attached to the drill shaft. I corrected the problem using a 3 square file to cut channels lengthwise inside the handle. Then I cut grooves around the shaft. I drilled small holes in handle then cleaned everything with lacquer thinner. I pushed epoxy into the center hole until it flowed out the small drilled holes. Then I pushed the shaft back in and clamped it. Works well.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.