Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mount per RMR Trijicon per H&K USP - Alta qualità e precisione
Scopri il montaggio EGW per il tuo red dot Trijicon RMR, progettato specificamente per le pistole H&K USP. Questo supporto offre una soluzione semplice e efficace per migliorare la tua mira.
Descrizione del prodotto
- Materiale: Alluminio 7075
- Rivestimento: Matte Black Hardcoat
- Dimensioni:
- Lunghezza totale: 1.780"
- Larghezza totale: 1.1"
- Hardware di montaggio: (2) viti a testa piatta 6-32, (1) vite di bloccaggio 6-32 X 3/16
- Compatibilità:
- Adatto per: Baby Desert Eagle (Post 2006), EAA Witness Elite Match
- Non adatto per: Rock Island 1911s
Per installare il tuo red dot Trijicon RMR, basta rimuovere il mirino posteriore della tua pistola e sostituirlo con il nostro supporto. Non sono necessarie modifiche e puoi rimuovere il montaggio in qualsiasi momento per ripristinare il mirino originale. Hardware di montaggio incluso.
Istruzioni per l'installazione
- Rimuovere il mirino posteriore*
- Installare il montaggio EGW nel dovetail
- Serrare la vite di bloccaggio (se applicabile)
- Posizionare il red dot sight sul montaggio EGW (inserire un piccolo pezzo di carta tra il red dot sight e il montaggio faciliterà la rimozione e proteggerà il red dot sight dal Loctite).
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
2 viti a testa piatta incluse - Fornite per Trijicon RMR. Le viti incluse richiedono una chiave a brugola da 5/64'' per l'installazione.