EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. Does not work with Ruger SR9E or Ruger SR22.
Scopri il montaggio ideale per il tuo Vortex Viper/Venom!
Il RUGER SR9, SR40, SR45 VORTEX VIPER/VENOM SIGHT MOUNT di EGW è progettato per offrire una soluzione di montaggio semplice e efficace per i tuoi mirini red dot. Questo montaggio è compatibile con i modelli RUGER SR9, SR40 e SR45.
Descrizione del prodotto
I mirini red dot di EGW sono progettati per essere installati da sinistra a destra (con la bocca rivolta in avanti). La slitta ha un'inclinazione progressiva per facilitare l'installazione. Segui questi semplici passaggi:
- Rimuovi il mirino posteriore dalla tua arma.
- Installa il montaggio EGW nella slitta.
- Serra la vite di fissaggio (se applicabile).
- Posiziona il mirino red dot sul montaggio EGW (mettere un piccolo pezzo di carta tra il mirino red dot e il montaggio faciliterà la rimozione e impedirà al Loctite di attaccarsi al mirino).
- Applica Loctite blu alle viti di montaggio fornite.
- Serra le viti di montaggio a 15 in/lbs.
Dettagli aggiuntivi
Inclusi nel montaggio:
- 2 Viti a testa bombata - Fornite per i mirini Vortex Viper e Venom.
- 2 Viti a testa piatta - Fornite per i mirini Burris FastFire e Docter.
Le viti incluse richiedono una chiave a brugola da 5/64'' per l'installazione.
Si prega di notare che la modifica della propria arma potrebbe annullare la garanzia del produttore. Questo prodotto dovrebbe essere installato e controllato da un armaiolo qualificato. Non si assume alcuna responsabilità per danni o infortuni che potrebbero derivare da un'installazione o un uso improprio di questo prodotto.
Nota: non compatibile con Ruger SR9E o Ruger SR22.