This mount is NOT a drop in part and will require fitting. EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. EGW products should be installed and checked by a qualified and competent gunsmith. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail after checking for fit Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount fits: Firearms with oversized Novak cut dovetails. This mount is made .007"" larger than a standard Novak cut and will require fitting.
Mount per Vortex Viper/Venom di alta qualità e personalizzabile
Il mount OVERSIZED NOVAK 0.007" VORTEX VIPER/VENOM è progettato per offrire una soluzione robusta e affidabile per il montaggio di ottiche red dot. Questo prodotto è realizzato da EGW e non è un componente di facile installazione; richiede un adattamento specifico.
Caratteristiche del prodotto:
- Compatibile con ottiche Vortex Viper/Venom, Burris FastFire e Docter.
- Realizzato con una tolleranza di .007" più grande rispetto a un taglio Novak standard.
- Installazione da sinistra a destra (con la bocca rivolta in avanti).
- Include hardware di montaggio e istruzioni dettagliate.
Istruzioni di installazione:
- Rimuovere la mira posteriore dal proprio fucile.
- Installare il mount EGW nella slitta dopo aver verificato la compatibilità.
- Serrare la vite di fissaggio (se applicabile).
- Posizionare l'ottica red dot sul mount EGW, utilizzando un piccolo pezzo di carta tra l'ottica e il mount per facilitare la rimozione e mantenere il Loctite lontano dall'ottica.
- Applicare Loctite blu alle viti di montaggio fornite.
- Serrare le viti di montaggio a 15in/lbs.
Nota: Le viti incluse richiedono una chiave a brugola da 5/64'' per l'installazione. La modifica della propria arma può annullare la garanzia del produttore.
Si raccomanda che questo prodotto venga installato e verificato da un gunsmith qualificato. Non si assume alcuna responsabilità per danni o infortuni che possono derivare da un'installazione o un uso improprio di questo prodotto.
Questo mount è adatto per armi con slitte a taglio Novak oversized.