EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
Mount per il mirino Leupold DeltaPoint Pro per Desert Eagle Pre 2017
Il montaggio EGW per il mirino red dot è progettato per essere installato da sinistra a destra (con la volata rivolta in avanti). Il profilo a coda di rondine presenta una riduzione progressiva per facilitare l'installazione.
Rimuovi semplicemente il mirino posteriore dalla tua arma e sostituiscilo con il montaggio EGW per installare il tuo Leupold DeltaPoint Pro, JPoint, Redfield Accelerator o Optima red-dot sight. Puoi rimuovere il montaggio e ripristinare il tuo mirino posteriore in qualsiasi momento. Hardware di montaggio incluso.
Istruzioni di installazione
- Rimuovere il mirino posteriore*
- Installare il montaggio EGW nella coda di rondine
- Serrare la vite di fissaggio (se applicabile)
- Posizionare il mirino red dot sul montaggio EGW (mettere un piccolo pezzo di carta tra il mirino red dot e il montaggio faciliterà la rimozione e manterrà il Loctite lontano dal mirino red dot)
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
La modifica della tua arma potrebbe annullare la garanzia del produttore. Questo prodotto dovrebbe essere installato e controllato da un armaiolo qualificato. Non si assume alcuna responsabilità per danni o infortuni che possono derivare da un'installazione o un uso improprio di questo prodotto.
Questo montaggio non si adatta a:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Si prega di notare le differenze tra Pre 2017 e Post 2017 durante l'ordine.
- La mensola posteriore Pre 2017 dietro la coda di rondine è di .187"
- La mensola posteriore Post 2017 dietro la coda di rondine è di .120"