Caratteristiche
- Peso della spedizione: 0,159kg
- Altezza di spedizione: 58mm
- Larghezza di spedizione: 61mm
- Lunghezza di spedizione: 173mm
- UPC: 050806104372
N. prodotto: 080739000
050806104372 Risolvi il problema del "scivolamento della ramp quando la saldatura si scioglie" grazie a un pistone a molla appuntito che mantiene una pressione costante sulla ramp o su un mirino .45, anche quando la saldatura fluisce. Regolabile in altezza, angolo e quantità di pressione della molla. La base a blocco "V" non danneggia e centra il canna sotto il pistone. Tiene anche in posizione le basi dei mirini posteriori. Ottima clearance per la torcia.Tempi di consegna circa 12-16 giorni.
Il RAMP SOLDERING JIG di BROWNELLS risolve il problema del "ramp slips just as the solder melts" grazie a un pistone a molla con punta che mantiene una pressione costante sul ramp o su un mirino .45, anche quando la saldatura fluisce.
Regolabile per altezza, angolo e quantità di pressione della molla. La base a blocco "V" non danneggiante centra il barile sotto il pistone. Tiene ferme anche le basi dei mirini posteriori. Ottima clearance per la torcia.
Defective 31/07/2015
I purchased one of these jigs several years ago but did not try it out until recently. The spring-loaded plunger was not perpendicular to the base, so it sat at a slight angle of 5-10 degrees. This prevented full downward pressure onto the workpiece and tended to cause slippage. The plunger has a pointed tip which provides for a less secure hold than a flat tip. I suppose a small flat could be ground on it. To prevent sight rotation during soldering, the base needs to be sitting on a flat surface. Since temperatures are around 1000 degrees, a metal table is the only suitable work surface. The barrel needs to be level and secure as well, so a padded vise is advisable. This requires aligning the vise and metal table so the sight and barrel are level with the jig. It's a clever design, so I am returning the jig for replacement. Hopefully the next one will be more square.
Love this Jig 21/05/2011
Used this jig to silver solder Moison nagant front sights back on. Got it on perfect.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.