Polish Chamfers; Lap Sharp Edges; Improve Accuracy
Use to polish after using 45° Chamfer Cutters; or for lapping out dings, sharp edges, etc., by itself. Improves accuracy. Use with abrasive paste - like our Silicon Carbide grits - mounted in variable speed electric drill. Made of half-hard brass to hold polishing grit well without excessive tool wear.
Utilizzare per lucidare dopo usando frese smusso di 45°; o per lappatura fuori ammaccature, affilati spigoli, ecc., di per sé. Migliora l'accuratezza. Utilizzare con pasta abrasiva - come nostri grane di carburo di silicio - montato nel trapano elettrico a velocità variabile. In ottone metà-difficile tenere lucidatura graniglia bene senza usura eccessiva utensile.
Numero di punteggi: 1
Da brownells.com: 1
Punteggio medio: 5
45° BRASS MUZZLE LAP(04/06/2016)
Used this with Brownells 45 degree, 5/8" chamfer cutter (#080-588-625) to re-crown several guns. The shalf is 1/4" dia. Almost didn't need it as the cutter did such a good job. I used Brownells 320 grit Abrasive Compound, that I had previously purchased to recut/polish a few forcing cones & hand lap a barrel constriction.
Polish Chamfers; Lap Sharp Edges; Improve Accuracy
Use to polish after using 45° Chamfer Cutters; or for lapping out dings, sharp edges, etc., by itself. Improves accuracy. Use with abrasive paste - like our Silicon Carbide grits - mounted in variable speed electric drill. Made of half-hard brass to hold polishing grit well without excessive tool wear.
Utilizzare per lucidare dopo usando frese smusso di 45°; o per lappatura fuori ammaccature, affilati spigoli, ecc., di per sé. Migliora l'accuratezza. Utilizzare con pasta abrasiva - come nostri grane di carburo di silicio - montato nel trapano elettrico a velocità variabile. In ottone metà-difficile tenere lucidatura graniglia bene senza usura eccessiva utensile.
Numero di punteggi: 1
Da brownells.com: 1
Punteggio medio: 5
45° BRASS MUZZLE LAP(04/06/2016)
Used this with Brownells 45 degree, 5/8" chamfer cutter (#080-588-625) to re-crown several guns. The shalf is 1/4" dia. Almost didn't need it as the cutter did such a good job. I used Brownells 320 grit Abrasive Compound, that I had previously purchased to recut/polish a few forcing cones & hand lap a barrel constriction.