Caratteristiche
- Calibro:
404 Jeffery (.422-.423)
- Peso della spedizione: 0,023kg
- Altezza di spedizione: 1mm
- Larghezza di spedizione: 83mm
- Lunghezza di spedizione: 146mm
Il Sinclair Chamber Length Gage, modello 404 JEFFERY CHAMBER LENGTH GAGE, è progettato per consentire ai ricaricatori di determinare la lunghezza effettiva della camera del proprio fucile, misurando dalla faccia dell'otturatore fino alla fine del collo della camera. Questa misurazione ti dirà quanto eccesso di lunghezza della cartuccia potrebbe avere la tua camera rispetto alle lunghezze di taglio pubblicate nei manuali di ricarica.
Le differenze tra le lunghezze di taglio pubblicate e la lunghezza effettiva della tua camera possono essere significative. Potresti star accorciando le tue cartucce di oltre .030 pollici. Nota: il misuratore calibro 22 non funziona con cartucce a collo sottile come il 22 Hornet, 218 Bee o cartucce basate su questi casi. Il misuratore calibro 30 non funziona con il 30-30 Winchester. Nessuno dei misuratori elencati funziona su camere a collo stretto, tranne il G-243T. Non deve essere utilizzato in pistole, fucili semiautomatici, fucili a leva e fucili a pompa.
404 Jeffery (.422-.423)
5.56 NATO gaged Chamber length new DPMS 10/09/2016
Followed instructions as provided and measured the chamber 3 times and the length came out exactly 1.781 on the chamber. Knowing this I will size all my Lake City brass to 1.771. Which is where the vast major of measures to any way. Now I have confidence in my reloads thanks to this marvelous little cheap gage. I will keep all my brass separate and will use the 1.771 brass for match shooting and everything else for plinking.
Worked great 24/12/2015
I had no trouble making a case to accept this gauge. I'm not sure why so many reviewers had difficulties. To make this easier for you gents, trim a re-sized case to 1.640 then insert the gauge. Yes, the case looks short and only has a little bit of neck left, but it works great!
One thing I would change about the directions....it says to drill out the flash hole to make access to push the gauge back out. This is not needed. I used a kinetic bullet puller to "lengthen/re-set" the case with gauge installed. It only needs to be lengthened by 10 thou between uses.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.