Caratteristiche
- Calibro:
8 mm (.323)
- Peso della spedizione: 0,023kg
- Altezza di spedizione: 8mm
- Larghezza di spedizione: 58mm
- Lunghezza di spedizione: 109mm
- UPC: 011516719959
Il Universal Carbide Case Trimmer è uno strumento per la rifilatura dei bossoli costruito in ghisa pesante, progettato per i ricaricatori seri che richiedono lunghezze di bossolo precise per un'accuratezza impeccabile e cartucce funzionanti in modo fluido e affidabile.
Il segreto di questo trimmer per bossoli è semplice: utilizza un Carbide Cutter Head che mantiene un bordo affilato come un diamante, garantendo dimensioni bilanciate e una durata di servizio superiore alla media, rendendolo ideale per i ricaricatori ad alto volume.
Questo cutter head sostituibile accetta tutti i piloti Lyman. Questo dispositivo è dotato di un'unità ad alta velocità e di una protezione di sicurezza per una maggiore protezione.
Il Universal Chuckhead brevettato di Lyman può gestire qualsiasi lavoro di taglio di bossoli da .17 calibro a .458 calibro senza necessità di collets o supporti per bossoli.
Include anche nove dei piloti di calibro più popolari: 22, 24, 27, 28/7mm, 30, 9mm, 35 (38/357), 44 e 45A.
8 mm (.323)
Great Upgrade 06/01/2015
Yes, this part is a little on the high dollar side for it's size and design. However, I got the power adapter upgrade and the ole steel cutter was chewing up case mouths so bad it was hard to pull the pilot out at times. This carbide cutter takes care of that. It will be the last cutter head you will need to buy. Like I said, the only con is the price.
So far, so good 01/08/2013
I reload .204 Ruger, so needed the .20cal pilot.
Easy to adjust trim length. Screws down onto bench. Hand / wrist gets tired after trimming many cases, but the sharp cutter does make quick work of each case. Can be a pleasure when you get a rhythm going. Very heavy / sturdy base.
For those who have trouble / complaints with squaring cases, I noticed it pays to tighten the chuck only when the pilot is deep inside the case neck. Specs state the plastic contstructed chuck with ball bearing is self-centering, but if you just throw the case in and lock the chuck the case may not be square / centered at all -- you need that pilot in there to keep it all lined up before you begin cranking the handle, I reckon. I too, am worried about the 'life' of the spring loaded plastic chuck, getting loose over time.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.